Columbia cast iron turntable, actual diameter is 11-½”, fits conical spindle. Nickel plated.
I’ve had this part too long!
Free to the first responder. Just cover the postage.
Mark
FREE: Columbia 12” Cast Iron Turntable $0.00
-
- Victor II
- Posts: 327
- Joined: Tue Jun 02, 2009 10:19 pm
- Location: Silver Spring, MD
-
- Victor IV
- Posts: 1601
- Joined: Wed Jan 07, 2009 7:44 pm
Re: FREE: Columbia 12” Cast Iron Turntable $0.00
I appreciate your offer. I think though its a different design. From my recall I think mine has a raised metal on the bottom that would hold it higher off the shaff. I will check it out though and let you know. I have to be gone this morning and the phonograph is at my moms home so I can't answer you till after I take her to an appointment this morning. My gut feeling is that its made differently so far as the shaff support goes.
Larry
Larry
- fmblizz
- Victor IV
- Posts: 1180
- Joined: Tue Jan 12, 2010 4:59 pm
- Location: South Jersey
Re: FREE: Columbia 12” Cast Iron Turntable $0.00
it appears in the second picture that the sleeve is raised....
blizz
blizz
-
- Victor IV
- Posts: 1601
- Joined: Wed Jan 07, 2009 7:44 pm
Re: FREE: Columbia 12” Cast Iron Turntable $0.00
I looked at mine today and its not the same design so far as the part that holds the shaft, plus then mine is a fairly decent gold finish still on the edges. I hope someone needs it, it was good of you to let me know about it.
Larry
Larry