WANTED: Spring barrel shaft or pin/Victor X
- CharliePhono
- Victor III
- Posts: 788
- Joined: Fri Sep 30, 2016 2:41 pm
- Personal Text: "The kerosene record player is not a very efficient device." ~Frank Zappa
- Location: North Fork, CA
WANTED: Spring barrel shaft or pin/Victor X
After finally getting into the motor of the Victor X table model, I sadly saw where the encircled pin was sheared off at some point. Would anyone have said pin or even an entire shaft for sale? Please & thank you!
- Attachments
-
- IMG_0897.JPG (118.35 KiB) Viewed 185 times
- gramophone-georg
- Victor VI
- Posts: 3992
- Joined: Mon Jan 20, 2014 11:55 pm
- Personal Text: Northwest Of Normal
- Location: Eugene/ Springfield Oregon USA
Re: WANTED: Spring barrel shaft or pin/Victor X
Charlie- BTDT- tap it out with a hammer and small punch and use an appropriate diameter nail trimmed down.CharliePhono wrote: ↑Fri May 21, 2021 1:16 pm After finally getting into the motor of the Victor X table model, I sadly saw where the encircled pin was sheared off at some point. Would anyone have said pin or even an entire shaft for sale? Please & thank you!
"He who dies with the most shellac wins"- some nutty record geek
I got PTSD from Peter F's avatar
I got PTSD from Peter F's avatar
-
- Victor Monarch Special
- Posts: 5334
- Joined: Mon Aug 24, 2009 3:08 pm
- Location: Southeast MI
Re: WANTED: Spring barrel shaft or pin/Victor X
What Greorg said...gramophone-georg wrote: ↑Fri May 21, 2021 1:54 pmCharlie- BTDT- tap it out with a hammer and small punch and use an appropriate diameter nail trimmed down.CharliePhono wrote: ↑Fri May 21, 2021 1:16 pm After finally getting into the motor of the Victor X table model, I sadly saw where the encircled pin was sheared off at some point. Would anyone have said pin or even an entire shaft for sale? Please & thank you!
Or, take the remaining bit to a hobby shop where they'll have steel rods of various diameters and lengths. Match up the diameter, buy one of those, cut to length, presto!
- CharliePhono
- Victor III
- Posts: 788
- Joined: Fri Sep 30, 2016 2:41 pm
- Personal Text: "The kerosene record player is not a very efficient device." ~Frank Zappa
- Location: North Fork, CA
Re: WANTED: Spring barrel shaft or pin/Victor X
Thank you, George and Jerry!JerryVan wrote: ↑Fri May 21, 2021 8:08 pmWhat Greorg said...gramophone-georg wrote: ↑Fri May 21, 2021 1:54 pmCharlie- BTDT- tap it out with a hammer and small punch and use an appropriate diameter nail trimmed down.CharliePhono wrote: ↑Fri May 21, 2021 1:16 pm After finally getting into the motor of the Victor X table model, I sadly saw where the encircled pin was sheared off at some point. Would anyone have said pin or even an entire shaft for sale? Please & thank you!
Or, take the remaining bit to a hobby shop where they'll have steel rods of various diameters and lengths. Match up the diameter, buy one of those, cut to length, presto!