Ok now I’m back working on my B-19 machine, for some reason only one screw was left holding the pawl to the motor frame when there should have been four.
Does anybody have a full set or at least 3 winding pawl screws?
Thanks as always!
WANTED: Edison Diamond Disc Winding Pawl Screws
-
- Victor V
- Posts: 2423
- Joined: Fri May 26, 2017 10:15 pm
- Location: A small town near Omaha, Nebraska
-
- Victor Monarch Special
- Posts: 5345
- Joined: Mon Aug 24, 2009 3:08 pm
- Location: Southeast MI
Re: WANTED: Edison Diamond Disc Winding Pawl Screws
I think you're looking for the screws that attach the winding shaft bracket?
-
- Victor VI
- Posts: 3751
- Joined: Mon Oct 03, 2011 7:54 pm
Re: WANTED: Edison Diamond Disc Winding Pawl Screws
IIRC, you need to be a bit careful with this because the four screws are not the same. The two "front" ones are, as are the two "back" ones, but the "Front" and "back" are slightly different lengths.
-
- Victor V
- Posts: 2423
- Joined: Fri May 26, 2017 10:15 pm
- Location: A small town near Omaha, Nebraska
-
- Victor V
- Posts: 2423
- Joined: Fri May 26, 2017 10:15 pm
- Location: A small town near Omaha, Nebraska
Re: WANTED: Edison Diamond Disc Winding Pawl Screws
Ok. I ordered some screws that could possibly fit (2 larger and 2 smaller ones) but not ready to put found yet