FOUND: 7" VICTOR TURNTABLE PLATTER

erunltd · Post by **erunltd** » Tue Mar 21, 2023 11:49 pm

The title tells the story.

I could actually use two platters.

Thx for looking

Post by **Phono-Phan** » Wed Mar 22, 2023 11:48 am

Harry,
I think I have one. Let me do some digging.
Ken Brekke

Kevin Clark · Post by **Kevin Clark** » Wed Mar 22, 2023 11:59 am

Have some as well.

gunnarthefeisty · Post by **gunnarthefeisty** » Wed Mar 29, 2023 4:21 am

If anyone, by some chance, has a third. I could use one as well.

Kevin Clark · Post by **Kevin Clark** » Wed Mar 29, 2023 11:40 am

Offered up three that I had available. Have one left. In the photos it is the one at the top. This turn table came off a Victor C. With no felt, rusty no nickel plating left was sent to the plater with instructions to only polish the rim and bead blast everything else. This was not followed as they tried to polish the back side and for unknown reasons decided to grind on the boss. Spindle hole is 5/16 and the slot width is for a 3/32 drive pin. Works as intended. Price is 60.00 plus shipping

FOUND: 7" VICTOR TURNTABLE PLATTER

FOUND: 7" VICTOR TURNTABLE PLATTER

Re: WANTED: 7" VICTOR TURNTABLE PLATTER

Re: WANTED: 7" VICTOR TURNTABLE PLATTER

Re: FOUND: 7" VICTOR TURNTABLE PLATTER

Re: FOUND: 7" VICTOR TURNTABLE PLATTER