Page 1 of 2
Victor Concert
Posted: Sat May 26, 2012 6:59 pm
by pappde
How do you take apart a Victor Concert soudbox?
Re: Victor Concert
Posted: Sat May 26, 2012 7:05 pm
by kirtley2012
a pic may help
Re: Victor Concert
Posted: Sat May 26, 2012 7:07 pm
by gramophone78
delete
Re: Victor Concert
Posted: Sat May 26, 2012 9:17 pm
by pappde
How do I remove it?
Re: Victor Concert
Posted: Sat May 26, 2012 9:20 pm
by gramophone78
delete
Re: Victor Concert
Posted: Sat May 26, 2012 9:52 pm
by saxymojo
Hi
This type of sound box? To take this apart you will have to sacrifice the mica. First remove the needle bar, then remove the mica by breaking it. Then you need to clamp the
reproducer in a vice with wooden jaws, use a wooden dowel and gently tap through where the mica use to be, working in circles close to the outer edge to release it evenly, keep tapping away, just watch that when it comes free that it does not hit a concrete floor
Regards Marcel
Re: Victor Concert
Posted: Sat May 26, 2012 10:01 pm
by pappde
gramophone78 wrote:Good question. Just press the "blue "X" mark you see in all your postings. It is located in the bottom right corner of "each post". I will now remove my other post and then this one after you.If you are not able to delete. Just edit your posts with "delete" and the moderator if remove. Then, by all means re-post this topic in "tips & tech" and I'm sure you will get help.

Can not find the Blue X
Re: Victor Concert
Posted: Sat May 26, 2012 10:02 pm
by pappde
Thanks.
I got the answer!
To my original question!!
Re: Victor Concert
Posted: Sat May 26, 2012 11:30 pm
by phonojim
I believe this procedure is described in The Compleat Talking Machine by Eric Reiss. Look for a second or later edition. I Know it is not in the first.
Jim
Re: Victor Concert
Posted: Mon May 28, 2012 6:20 pm
by Yamaphone
It is possible to disassemble the Victor Concert reproducer without damaging any part by using a simple tool, a diagram of which I have attached. I do not presently have a Concert reproducer so I can not add any dimensions. It is simply a steel tube, bored out on a lathe and anyone who can do this work can easily establish the dimensions as long as they have a Concert reproducer.In use, the reproducer slips into the tool until the edge of the reproducer body contacts the ledge inside the tool. If the tool is struck as shown, the body will naturally want to move to the left, but the inertia of the tube end will want to prevent it from moving and it will be pulled out.It is a handy tool for anyone who works on the reproducers as they can be repeatedly opened if necessary.
I hope the diagram copies clearly.
Dan Zalewski