FOR SALE: Victor II / III Elbow Slip-In style $300 free ship
- Crank_it_up
- Victor III
- Posts: 586
- Joined: Thu May 01, 2014 8:34 pm
- Location: South Florida
FOR SALE: Victor II / III Elbow Slip-In style $300 free ship
I am offering an original Victor slip in style that is correct for later Vic II (2) and III (3) rear mount machines. The dimensions are approx 1-5/16" O.D for the small end that slips into the back bracket and approx 2-¼" I.D on the large end. See the pictures, it is in great condition. The openings are very well shaped and virtually dent free. There is a small spot where the plating has been rubbed through but does not distract from its otherwise great finish. These very rarely show up loose. Any questions or commit to buy please PM me. Free Shipping within the Continental USA. Payment to be with personal check or money order. Thanks, Joe
- Attachments
-
- IMG_2903.jpg (87.47 KiB) Viewed 837 times
-
- IMG_2905.jpg (96.97 KiB) Viewed 837 times
-
- IMG_2907.jpg (102.79 KiB) Viewed 837 times
-
- IMG_2908.jpg (76.83 KiB) Viewed 837 times
-
- IMG_2914.jpg (80.86 KiB) Viewed 837 times
-
- IMG_2910.jpg (85.87 KiB) Viewed 837 times
- Crank_it_up
- Victor III
- Posts: 586
- Joined: Thu May 01, 2014 8:34 pm
- Location: South Florida
Re: FOR SALE: Victor II / III Elbow Slip-In style $300 free
I still have this elbow available. Make an offer.
Joe
Joe
-
- Victor Monarch Special
- Posts: 8516
- Joined: Tue Feb 10, 2009 11:25 am
- Personal Text: Stop for a visit when in Oregon.
- Location: Albany, Oregon
Re: FOR SALE: Victor II / III Elbow Slip-In style $300 free
Interesting, I didn't realize that the part of the elbow that mated with the back bracket was the same size on the late Victor II as the Victor III.
Thanks Jerry
Thanks Jerry
- Crank_it_up
- Victor III
- Posts: 586
- Joined: Thu May 01, 2014 8:34 pm
- Location: South Florida
Re: FOR SALE: Victor II / III Elbow Slip-In style $300 free
Jerry, according to Baumbach's Victor Data Book late IV's and late V also used a slip in elbow but there is mention of a ball bearing taper arm. Since I have never seen that setup in person I can't assure it fits. This one came with a good portion of a Vic II but was missing the motor and back bracket. I added dimensions so a proper fit is assured.
Thanks, Joe
MAKE AN OFFER!
Thanks, Joe
MAKE AN OFFER!