Early Silvertone table model, governor bearing adjustment
-
- Victor O
- Posts: 51
- Joined: Sat Nov 21, 2020 7:42 pm
- Personal Text: Edison is still a better inventor than Tesla
Early Silvertone table model, governor bearing adjustment
Hello all. I've had an early Silvertone table model for years. Had a broken spring in it. I just recently got around to repairing the spring. Just like my VV-XVI, it simultaneously runs down when it wants. I completely went through everything when fixing the spring, cleaning every single part. It has a pillar and plate motor, unknown manufacturer. I know the spring and other gears are fine. The spindle gear that the governor turns is steel with fiber teeth. The governor bearings, or business rather, have offset holes in them where the pins on each end of the governor ride. I've never seen bushings with offset holes like that, only with the holes in the very center but I'm used to Victor machines mainly. They are apparently there for adjustment adjustment. I believe I don't have them adjusted properly, and I didn't pay attention to them when removing, as I did not expect those offset holes. Does anyone have experience with bushings/bearings like these? If so, what would relatively proper adjustment look like? I figured that this would be the best place to ask if there ever was one. Thank you.
-
- Victor IV
- Posts: 1229
- Joined: Wed Aug 01, 2012 8:43 pm
- Location: Port Huron, MI
Re: Early Silvertone table model, governor bearing adjustmen
I make this adjustment without the spring barrels in place. Adjust the bearings so that the spindle shaft gear and the governor are meshing and spin properly. There is a section about this in The Compleat Talking Machine.
Dave D
Dave D
-
- Victor O
- Posts: 51
- Joined: Sat Nov 21, 2020 7:42 pm
- Personal Text: Edison is still a better inventor than Tesla
Re: Early Silvertone table model, governor bearing adjustmen
And what should that look like properly meshed? Also, that's one book I don't have yet.
-
- Victor O
- Posts: 51
- Joined: Sat Nov 21, 2020 7:42 pm
- Personal Text: Edison is still a better inventor than Tesla
Re: Early Silvertone table model, governor bearing adjustmen
Also, should both bearings be in the same position when properly adjusted?