Page 2 of 2
Re: Model H reproducer question...
Posted: Mon Apr 29, 2013 2:50 pm
by howardpgh
I was looking at the macro picture of the H stylus and can't see where it is.
I am trying to compare my H to it, but with my bad eyesight, I don't see the stylus and what it's supposed to look like. Is the stylus that tiny?
Re: Model H reproducer question...
Posted: Mon Apr 29, 2013 6:41 pm
by Le0
howardpgh wrote:I was looking at the macro picture of the H stylus and can't see where it is.
I am trying to compare my H to it, but with my bad eyesight, I don't see the stylus and what it's supposed to look like. Is the stylus that tiny?
well it is about 1mm or 5/128 on the H reproducer I have but pictures of the "real deal" I've seen on this thread are substantially smaller.
Re: Model H reproducer question...
Posted: Tue Apr 30, 2013 12:03 am
by Lucius1958
howardpgh wrote:I was looking at the macro picture of the H stylus and can't see where it is.
I am trying to compare my H to it, but with my bad eyesight, I don't see the stylus and what it's supposed to look like. Is the stylus that tiny?
The 'H' stylus is mounted on the side of the bar - about 90 degrees from where a 2 minute stylus would be: you can see the end of it in the side view.
Bill