Dash pots on a Victrola Credenza? Vibration problem solved!

CDBPDX · Post by **CDBPDX** » Fri Aug 21, 2015 3:52 am

Vibration can usually be traced to the governor weights being out of balance. Did you check that?

Cliff

marcapra · Post by **marcapra** » Fri Aug 21, 2015 5:32 am

Well, wouldn't missing a governor weight be considered to be out of balance?

De Soto Frank · Post by **De Soto Frank** » Fri Aug 21, 2015 7:32 am

Sounds like that is easily resolved.

Personally I haven't run across a Victrola that "threw" a governor weight, so that possibility did not occur to me...

marcapra · Post by **marcapra** » Mon Aug 24, 2015 1:55 am

Today, I successfully rebuilt my dash pots, thanks to the great videos on Youtube that the Credenza man did! He really shows you how to do it right! The hardest part was getting the spring clips back in. Now the dash pots feel very firm. I can't wait to install them back into the Credenza to see how they work. Also there is an adjustable knob in the bottom of the dash pot where you can adjust the speed of the descent!

FloridaClay · Post by **FloridaClay** » Mon Aug 24, 2015 10:45 am

estott wrote:
JerryVan wrote:I've had several Credenzas and they've all had faulty dashpots. The only thing I've ever had to do to fix them was to squirt some light oil into the small holes at the top of the dashpot cylinder. Work the lid up and down a few times, wait for the oil to soak in, and they'll be good for years.
Seconded- if you can't get to the holes then let some oil run down the rods and it will find its way into the cylinder. It only takes a little.

Ditto to all the above. It is usually unnecessary to take them apart.

Clay

Dash pots on a Victrola Credenza? Vibration problem solved!

Re: Dash pots on a Victrola Credenza? Vibration problem sol

Re: Dash pots on a Victrola Credenza? Vibration problem sol

Re: Dash pots on a Victrola Credenza? Vibration problem sol

Re: Dash pots on a Victrola Credenza? Vibration problem sol

Re: How do you fix the dash pots on a Victrola Credenza?