Re: Is this the correct key?
Posted: Fri Dec 07, 2018 11:02 pm
I'm not 100% sure but here's my take on it. I have a Brunswick and took pictures of both the key next to a tape measure as well as it in the machine.
The key measure just over 2" and sticks out of the machine a bit while engaged in the lock. I think 3" would stick out too far.
I know there are a few on Ebay of the one I have posted for between $15-20.
Good luck with your project.
Mike
The key measure just over 2" and sticks out of the machine a bit while engaged in the lock. I think 3" would stick out too far.
I know there are a few on Ebay of the one I have posted for between $15-20.
Good luck with your project.
Mike