https://forum.talkingmachine.info/
Still very far from me, and I'm looking for a machine to salvage some part off of/get my hands on to machine new ones.
Jerry is right... if that left door is gone, it would be practically impossible to replace it. The carved molding can't be replaced (at least not reasonably) and if it could, it would cost more than the machine is worth... This is best for parts, IF you can buy it cheap...JerryVan wrote:With all due respect, it's gonna take a lot of veneer to completely replace the left side door. Not seeing it in any of the photos.VanEpsFan1914 wrote:Very saveable from the pictures--why is replacing veneer considered "Advanced" woodworking? You get some new, find some big clamps, stick it on and refinish the thing (which it needs anyway), have your new pieces made up for whatever trim has doubtless fallen off--and you're good!
It's really a nice machine. If the big spruce horn is intact then it should be a good project.
