The Talking Machine Forum — For All Antique Phonographs & Recordings

Mark Hagen wrote: Mon Aug 23, 2021 5:21 pm Here a picture of what I have. When put together, the short part is 5 ½ inches and the long part with the chain is 18 ½ inches, ¼ inch in diameter.
I think this fix a Edison Gem and some Fireside models.

Mark

Hey Mark, thanks for finding the crane to send pictures. Unfortunately that's not the type of crane I'm looking for, that's for a straight horn, Im looking for a crane for a Cygnet horn, the type that curves and hangs above. Thanks though, I'm sure someone else would be interested in buying it off you if you're interested in selling it still

If you are looking for a cygnet crane for a Fireside with an angled carriage, the crane you are looking for would like like this:

I should have a spare in the shop. I'll get by there tomorrow night to put hands on it and get pics. You are welcome to try it for fit first since your somewhat local

No problem.

Good luck, Mark

Here a picture of what I have. When put together, the short part is 5 ½ inches and the long part with the chain is 18 ½ inches, ¼ inch in diameter.
I think this fix a Edison Gem and some Fireside models.

Sorry Mark but your crane is for the small straight morning glory horn used on some Gems and Firesides. The thread author is looking for a crane for the curved Cygnet horn.

Jerry Blais

What I have to offer

Pictures

That crane is for a horizontal carriage with a Diamond B reproducer. I think the crane for an angled carriage is what is needed.

Chris,
Did Danny Arms woodgrain your horn?

Curt A wrote: Wed Aug 25, 2021 11:49 am Chris,
Did Danny Arms woodgrain your horn?

Yes this is one Danny did for me probably 20 years ago