Re: Wanted: Zonophone Crank
Posted: Sat Feb 05, 2022 1:52 pm
Found the crank. Never have used it so it’s just as Ron made it. Length of shaft is 1.020 inches. O.D. Of shaft is .500
I.D.of shaft is .312. Distance from center of shaft to center of pin that supports the wood knob is 1.90 inches. Add in 12.00 for shipping. Will refund if less than that and it most likely will be. The flat rate box is rather thin so will ship in bigger cube shaped box. Pretty quick turn around on your search. Do not know how many of these cranks Ron made. Rarer than an original. I had intended on using the first one I bought until I could find an original one. After seeing Ron’s crank I decided I didn’t need an original one. Base metal is steel.
My email address is. [email protected]
I.D.of shaft is .312. Distance from center of shaft to center of pin that supports the wood knob is 1.90 inches. Add in 12.00 for shipping. Will refund if less than that and it most likely will be. The flat rate box is rather thin so will ship in bigger cube shaped box. Pretty quick turn around on your search. Do not know how many of these cranks Ron made. Rarer than an original. I had intended on using the first one I bought until I could find an original one. After seeing Ron’s crank I decided I didn’t need an original one. Base metal is steel.
My email address is. [email protected]