The Talking Machine Forum — For All Antique Phonographs & Recordings

Sherazhyder wrote: Mon Mar 20, 2023 12:09 am Hi Pallophotophone ! Do you mean 3/16 mm ? Because 3/16 inches is too big a size for that tiny hole. Thanks

Hi Sheraz, I've only had to replace 2 of these ball bearings and they were both 3/16 inches. They fit the hole in the casting perfectly ! Why they were missing to begin with remains a mystery as they are hard to remove even if you wanted to. Both were used in the motor that is used in the Victor VV-VI (6) machine

Hi Pallophotophone ! Thanks for your advice