Page 2 of 2
Re: Slip in horn “sag”….
Posted: Thu Apr 06, 2023 7:18 pm
by Flying Dutchman
Yeah, a 6 jaw lathe chuck is not in my toolbox..unfortunately
Re: Slip in horn “sag”….
Posted: Thu Apr 06, 2023 8:12 pm
by Phono-Phan
I agree that trying to expand the elbow will risk breaking the seam open. Find a wood dowel that is just under the size of the elbow. Put the dowel in a vice. And then insert the elbow over the dowel and lightly tap on the outside of the elbow where it is out of round with a rubber hammer.
Re: Slip in horn “sag”….
Posted: Fri Apr 07, 2023 7:29 am
by Flying Dutchman
Another great idea. Appreciate all your advice.