Page 3 of 3
Re: Victrola VV-XI Table Model - Just Got It
Posted: Wed Jul 09, 2014 2:25 pm
by miker2001
Good going, Cliff. I see you posted it one day and the VERY NEXT day it was repaired! Not bad!!! Congrats on the find and the quick repair.
Re: Victrola VV-XI Table Model - Just Got It
Posted: Wed Jul 09, 2014 4:13 pm
by FloridaClay
I had forgotten about the difference on models with the bullet brake. That makes sense. Gold being somewhat soft that type of brake would likely quickly wear it off.
Clay
Re: Victrola VV-XI Table Model - Just Got It
Posted: Thu Jul 10, 2014 2:17 am
by CDBPDX
miker2001 wrote:Good going, Cliff. I see you posted it one day and the VERY NEXT day it was repaired! Not bad!!! Congrats on the find and the quick repair.
I was anxious to get it up and running. Didn't know how far I was going to get putting the motor together, wasn't sure if all the parts were there, but they were!
I flattened out the turntable so no more wobble. View a new video on YouTube here:
http://youtu.be/7rAFZ5YLKu4
Cliff
Re: Victrola VV-XI Table Model - Just Got It
Posted: Thu Jul 10, 2014 6:41 pm
by CDBPDX
Looks like it might clean up OK.
Re: Victrola VV-XI Table Model - Just Got It
Posted: Fri Jul 11, 2014 10:43 am
by Scott
Looking great! Can't wait to see the finished product.
Scott
Re: Victrola VV-XI Table Model - Just Got It
Posted: Fri Jul 11, 2014 10:56 am
by atopolosky
Can you post a pic of the insides of the record cabinet? I am looking to rebuild one. Thanks - Al