My New Addition...

[ehs004]

Here is a pic of the lock next to my original... not sure if it's the same on a BS. Look at the pic and compare it to yours, The lock is 1 ¾" wide x ⅜" deep x 1 ½" high. The keyhole is ¾" from the top and ¾" from the side (offset, not centered) to the center of the keyhole. If those measurements are the same as your original, it will work. I unscrewed mine and put one of these in its place - screw holes and cutout matched perfectly. Let me know, since it is impossible to find NOS locks & keys for these. The lock on top with the brass back is the original...

Curt,
Thanks for the photos and info but there not the same , mine is much smaller.
Thanks Eric

[phonogfp]

Congratulations on your AS! In my world, any coin-op Graphophone is a standout. Enjoy - -

George P.

[Remmotors]

Beautiful machine!