Page 1 of 1
Edison Gem
Posted: Sun Dec 09, 2012 9:29 am
by Dave D
I just found an Edison Gem with a banner lid. It is serial number G145780. Is the banner lid correct for this? I need a piece of lid molding, too if anyone has a junker lid. The piece on need is on the right side, the small piece at the back. Thanks!
Dave D
Re: Edison Gem
Posted: Sun Dec 09, 2012 10:55 am
by Jerry B.
A Gem lid with a banner label spanned the later Gem A's to the early B's. Any Gem with a key will not have a slot in the lid while every crank wound Gem will have a slot in the lid for the crank. I hope this helps. Jerry
Re: Edison Gem
Posted: Sun Dec 09, 2012 11:07 am
by Dave D
So, this is probably the right lid for this machine. Good to know.
Thanks for the reply. Anybody got the molding for me?
Dave D
Re: Edison Gem
Posted: Sun Dec 09, 2012 11:46 am
by gramophone78
Dave D wrote:So, this is probably the right lid for this machine. Good to know.
Thanks for the reply. Anybody got the molding for me?
Dave D
Place an ad in our "Yankee Trader" section of our forum so members can see what part your looking for
.