Page 1 of 1
WTB Edison B Carrage arm
Posted: Wed Dec 26, 2012 8:14 pm
by edisonrestorer64
- this is the carrage arm i need for my B home. this one is broken tried reparing it did not work
I want the one with the leaver on side as pictured below. However but not broken mine broke and is un repairable.
Thank You for any and all help
Re: WTB Edison B Carrage arm
Posted: Wed Dec 26, 2012 9:38 pm
by Chuck
Never say never...
I know a gentleman who works magic with brazing
cast iron. That carriage could most likely
be repaired.
Chuck
Re: WTB Edison B Carrage arm
Posted: Thu Dec 27, 2012 11:54 am
by edisonrestorer64
Hello Chuck it rebroke after i used JBweld it just did not slide right on the bar . It is suppose to slide smoothly on the bar Ill send it if it does not cost too much to repair. My Mom is in Icu unit at the hospital so funding is very tight at this time
Thank Sincerely william
PS Please let me know either way on this if he can do this great but please it has to be mended properly so it glises accross on the bar
again Much Thanks
Re: WTB Edison B Carrage arm
Posted: Thu Dec 27, 2012 8:51 pm
by joybird
If Braze not available. I would Gel glue it in proper position and drill and insert 2 small expansion pins. Then you could JB weld it also.
Be aware JB Weld does not like oil. The cast needs to be very clean.
Have used this procedure many times
Good luck with it.
Bob T
Re: WTB Edison B Carrage arm
Posted: Thu Dec 27, 2012 9:34 pm
by Chuck
Sent you a PM.
Chuck
Re: WTB Edison B Carrage arm
Posted: Fri Dec 28, 2012 1:07 pm
by mark gaisser
HEY CHUCK....I HAVE THOSE IN STOCK FOR $25.00 IF YOU WANT ONE...IT SAVE TIME JUST BUYING ANOTHER ONE...IF YOU WANT IT EMAIL ME AT
[email protected] .
HAPPY NEW YEARS,
MARK AND DARCY
CROAKINFROG PHONOGRAPHS
Re: WTB Edison B Carrage arm
Posted: Sat Dec 29, 2012 5:00 pm
by edisonrestorer64
Hello Mark I also sent one
sincerely Bill PS I purchased the Bedplate rememeber the ebay guy Me LOL