Page 1 of 1
Edison C-150 Brackets Question
Posted: Thu Jan 03, 2013 8:32 am
by edisonrestorer64
n
The attachment 100_1095.jpg is no longer available
Hello Gang Happy New Year Guys,
I have a question. I am trying to finish my edison C-150 I found my Brackets from my edison parts box (3 Pcs). Are Brackets the same for all edison C-150 cases. Also is there a larger bracket hols that do not match up with my brackets, did someone make there own holes>??
Thank You for any and All Help I Greatly Appreciate All input.
Ill post pics shortly
from will
Re: Edison C-150 Brackets Question
Posted: Thu Jan 03, 2013 11:24 am
by 52089
The C-150 should have a single spring motor supported by the 3 brackets you show. This is then covered by 2 pieces of falsework, finished wooden pieces that fill the gap between the motor board and the cabinet.
My guess would be that someone removed the original falsework, brackets, and motor, then built the rails and drilled the new holes so that they could use another mechanism in this cabinet.
Re: Edison C-150 Brackets Question
Posted: Thu Jan 03, 2013 1:33 pm
by edisonrestorer64
Yes I am aware of that I also was thinking on that idea.
My intentions are as follows, I will do is get a dowell for one hole big enugh to fillit useing woodflue to hold it in place. Nex I also am going to totally remove all the upper woods that was placed there the railings of course. I have the upper wood piece to replacethat goes around.
and well otheris that I have to use the brackets I already have I think thaT than this all shoud be ok. I hope
Re: Edison C-150 Brackets Question
Posted: Thu Jan 03, 2013 7:01 pm
by edisonrestorer64
52089 wrote:The C-150 should have a single spring motor supported by the 3 brackets you show. This is then covered by 2 pieces of falsework, finished wooden pieces that fill the gap between the motor board and the cabinet.
My guess would be that someone removed the original falsework, brackets, and motor, then built the rails and drilled the new holes so that they could use another mechanism in this cabinet.
Your Absolutely Correct My friend they did but i am going to try to do my dardest to bring it bak as to the best of my ability
Re: Edison C-150 Brackets Question
Posted: Thu Jan 03, 2013 7:04 pm
by edisonrestorer64
Well I did the following this eve I removed the 2 crank escussions on the side I found the 3 holer where the Orignal goes I have one. I will also Block up the one not needed as to the best of my ability. I will also try to get the brackets mounted just as soon as i get the correctn screws there short fat wood screws with the rouned head kinda like me LOL
Thanks guy for the input