The Talking Machine Forum — For All Antique Phonographs & Recordings

Posted: **Sat Jan 12, 2013 10:26 am**

The Gear on this is very loose, .002 difference. Was original Pressed in ?

Anyone re attach one of these ?????

Open to suggestions.

Bob T
Wilmington, NC

Posted: **Sat Jan 12, 2013 1:42 pm**

Wouldn't some epoxy work fine? How about JB weld?

Posted: **Sat Jan 12, 2013 2:31 pm**

Jerry B. wrote:Wouldn't some epoxy work fine? How about JB weld?

Used Gorilla Gel Glue, seems to be holding. Time will tell.

Will use JB Weld if this fails.

Bob T

The Talking Machine Forum — For All Antique Phonographs & Recordings

Mandrel from Amberol B VI (Fireside) Gear ????

Mandrel from Amberol B VI (Fireside) Gear ????

Re: Mandrel from Amberol B VI (Fireside) Gear ????

Re: Mandrel from Amberol B VI (Fireside) Gear ????