Parting out Victor M
Posted: Wed Jan 30, 2013 5:45 pm
Hi. This time I have a Victor M I will be parting out. All original parts, as is. Pictures available. Thanks! John email to [email protected], PM or call 860-966-2827
Broken brake & crank, speed adjust - I think the crank can be fixed $50
BB Bolts with plate and screw Fits all Vic rear mounts $50
Exhibition Reproducer w early Round hole $75
Victor M case w motor board, corners sharp, complete columns SOLD
case has been stripped, needs refinish IMO
Tag I.D. Vic M SOLD
Turn table cast iron, thin rim, near perfect original felt SOLD
Tone arm dirty, will clean up, Fits D, M, III, IV, V, MS SOLD
Elbow, good nickel some wear SOLD
19" Victor MG Horn some creases, looks good, nice decal SOLD
Victor M Motor, works fine SOLD
Back Bracket, decent 60% pinstripe, fits other Vic's SOLD
Plus shipping. Combined shipping no problem. JD
Broken brake & crank, speed adjust - I think the crank can be fixed $50
BB Bolts with plate and screw Fits all Vic rear mounts $50
Exhibition Reproducer w early Round hole $75
Victor M case w motor board, corners sharp, complete columns SOLD
case has been stripped, needs refinish IMO
Tag I.D. Vic M SOLD
Turn table cast iron, thin rim, near perfect original felt SOLD
Tone arm dirty, will clean up, Fits D, M, III, IV, V, MS SOLD
Elbow, good nickel some wear SOLD
19" Victor MG Horn some creases, looks good, nice decal SOLD
Victor M Motor, works fine SOLD
Back Bracket, decent 60% pinstripe, fits other Vic's SOLD
Plus shipping. Combined shipping no problem. JD