Electric Phono Motor Question / Fairy Phonograph Lamp
Posted: Thu Feb 14, 2013 11:27 pm
I am at my wits end, trying to find someone who can rewind/fix a motor for my Fairy Phonograph Lamp. What I am considering as a temporary fix (not altering the original parts in any way) was to use a 78 rpm turntable motor from a jukebox. Does anyone know of a direct drive type motor that would handle the weight of a 12" steel turntable and the resulting drag from the acoustic reproducer and steel needle?
I have been researching the original Fairy motor for over 8 months and cannot find anything about it regarding amps, hp and rpms - there is no tag on any of the three that I have looked at. I am restoring a second Fairy lamp that has the same motor problem as my first one - motor spins, but slows to a stop with any load. I have been told that the motor is a strange one since it is wound for three different types of power. Parts for these phonos are non-existent, thus the idea of using a strong jukebox turntable motor which is already running at 78 rpms. The original motor has a resistor to cut the power and uses a pulley - governor - worm screw to meshed gear transmission to run the turntable and the speed is controlled by a simple brake mechanism. Any ideas or suggestions would be greatly appreciated.
Curt
I have been researching the original Fairy motor for over 8 months and cannot find anything about it regarding amps, hp and rpms - there is no tag on any of the three that I have looked at. I am restoring a second Fairy lamp that has the same motor problem as my first one - motor spins, but slows to a stop with any load. I have been told that the motor is a strange one since it is wound for three different types of power. Parts for these phonos are non-existent, thus the idea of using a strong jukebox turntable motor which is already running at 78 rpms. The original motor has a resistor to cut the power and uses a pulley - governor - worm screw to meshed gear transmission to run the turntable and the speed is controlled by a simple brake mechanism. Any ideas or suggestions would be greatly appreciated.
Curt