The Talking Machine Forum — For All Antique Phonographs & Recordings

Before I go through the usual parts sources, does anyone had a standard feed screw cover they would sell? It's for a standard D, but I think they were the same for all of the standard models (the one from my model B fits, at least).

Thanks!

Hi,
I don't have an extra, but they are different for the Standard B and D.
Dave

Dave D wrote:Hi,
I don't have an extra, but they are different for the Standard B and D.
Dave

What are the differences? I took the one off of the B and put it on the D and it fit perfectly.

I don't see how you put one from a B on a D. The two bedplates are very different. The B uses a thin gear cover with two lugs that screw into the bedplate. The D just sets down over the gears and is held in place with a screw on the left side. Can you post a picture of the bedplate you want a gear cover for?

You are correct, the gear covers are completely different. However, I'm looking for a feedscrew cover, not a gear cover. Photo below:

yes I have one if I can locate it if you want it would cost you just the shipping $
email me [email protected]
sincerely bill

Please accept my apology. Your post clearly stated feed screw cover, yet I understood gear cover.
I am glad you found one and at such a good price!
Dave