WTB Vic III spring barrel and barrel shaft
Posted: Sun Jul 14, 2013 9:13 pm
Hi all,
I'm looking for the non gear barrel for a vic III 2 spring motor (see pic). The one I have is bent to the side enough to cause the other barrel with the brass gear riveted to wobble and slip when off the turntable shaft as it revolves. If a shaft that both barrels ride on is available, ill take that as the one I have is usable but the ends are wallered out. If I can't find one I may try to straighten the one I have but not sure how successful I'll be. Thanks
Brandt
I'm looking for the non gear barrel for a vic III 2 spring motor (see pic). The one I have is bent to the side enough to cause the other barrel with the brass gear riveted to wobble and slip when off the turntable shaft as it revolves. If a shaft that both barrels ride on is available, ill take that as the one I have is usable but the ends are wallered out. If I can't find one I may try to straighten the one I have but not sure how successful I'll be. Thanks
Brandt