Page 1 of 1
Need help with 2&4 Home and Triumph
Posted: Thu Jul 25, 2013 7:26 pm
by Jerry B.
I have an early suitcase Home with 2&4 minute gearing. I can get it to play two minute cylinders but not four minute cylinders. There doesn't seem to be enough room to shift gears. Is there a good step by step method to install the conversion? I don't think the problem is with incorrect conversion parts as this machine was dirty and appeared to have been together for years. Thanks, Jerry Blais
Re: Need help with 2&4 Home and Triumph
Posted: Fri Jul 26, 2013 12:20 am
by Lucius1958
Have you tried adjusting the position of the casting on which the shift lever sits?
Bill
Re: Need help with 2&4 Home and Triumph
Posted: Sat Jul 27, 2013 2:55 pm
by downsouth
Hey Jerry, I agree, check the position of the shifting lever itself. I had this same problem with a Triumph model A and it cured it.
Wes
Re: Need help with 2&4 Home and Triumph
Posted: Sun Jul 28, 2013 12:45 am
by Jerry B.
I'll give that a try. At the moment I'm punishing the Home and I set it aside to work on a Schwinn Tiger. Jerry