Page 1 of 1

WTB: Victor E parts

Posted: Thu Aug 29, 2013 3:12 am
by Lucius1958
I'm looking around for some good original parts for a Victor E:

. Record hold down
. Front bracket bolt
. Motor board stay arm
. Crank (have repro)

I haven't heard back yet from Wyatt's, and Ron Sisko only has repros.

(If I have to go with repros, is there any advice on techniques to blend them in with the rest of the machine? I realize the ethics involved, and would not represent them as original, should I ever resell it).

Bill

Re: WTB: Victor E parts

Posted: Thu Aug 29, 2013 4:54 am
by ambrola
I have a record hold down you can have. I don't think its original. Its just been in my parts forever.

Re: WTB: Victor E parts

Posted: Fri Aug 30, 2013 11:32 pm
by Lucius1958
Amberola wrote:I have a record hold down you can have. I don't think its original. Its just been in my parts forever.
Do you have a picture of it? If it doesn't look too 'new', I might consider it.

Bill

Re: WTB: Victor E parts

Posted: Sun Sep 01, 2013 12:26 am
by Lucius1958
Update: Tim Fabrizio has a very good original crank; will buy. :)

Re: WTB: Victor E parts

Posted: Sun Sep 01, 2013 2:44 pm
by ambrola
Lucius1958 wrote:
Amberola wrote:I have a record hold down you can have. I don't think its original. Its just been in my parts forever.
Do you have a picture of it? If it doesn't look too 'new', I might consider it.

Bill
I was offering to give it to you, and you might consider it? Forget it.

Re: WTB: Victor E parts

Posted: Sun Sep 01, 2013 9:10 pm
by Lucius1958
Amberola wrote:
Lucius1958 wrote:
Amberola wrote:I have a record hold down you can have. I don't think its original. Its just been in my parts forever.
Do you have a picture of it? If it doesn't look too 'new', I might consider it.

Bill
I was offering to give it to you, and you might consider it? Forget it.

Sorry: I did not understand you were offering it free of charge. :oops:

Bill