The Talking Machine Forum — For All Antique Phonographs & Recordings

Since i am unlikely to find an original for this, I thought I would ask whether I might get the specifications for the motor board support arm on my Victor E.

I have a rough idea of the necessary length, but if anyone could supply more accurate dimensions (width, thickness etc.), I would be grateful.

I would assume that the arm was originally riveted to its bracket, although it is hard to imagine how they could have become separated; I suppose I shall have to use a nut and bolt of suitable size.

Bill

Hi Bill
If you still need the support arm send me your address and I will mail one to you. After you get the support arm if you would send me back a few bucks for the padded envelope and shipping we'll be good.
Best Regards, Larry

PM sent. Thanks!

Bill