Page 1 of 1
Can someone identify this horn for me please?
Posted: Thu Dec 19, 2013 12:42 pm
by obmcclintock
Can someone identify this horn for me? It is 14 inches with a 9 inch bell and a 1 ⅛ inch opening on the opposite end. Thank you very much!!
Re: Can someone identify this horn for me please?
Posted: Thu Dec 19, 2013 12:49 pm
by VintageTechnologies
The only machine that comes to mind is a Columbia BC. Maybe the owner of one could confirm the dimensions.
Re: Can someone identify this horn for me please?
Posted: Thu Dec 19, 2013 1:47 pm
by ChuckA
obmcclintock wrote:Can someone identify this horn for me? It is 14 inches with a 9 inch bell and a 1 ⅛ inch opening on the opposite end. Thank you very much!!
Columbia Front mount machines AK, AJ, and similar
Chuck
Re: Can someone identify this horn for me please?
Posted: Thu Dec 19, 2013 1:56 pm
by obmcclintock
Thank you very much. I didn't think that it fit any type of cylinder machine because of the larger end. Does it fit into some sort of elbow?
Re: Can someone identify this horn for me please?
Posted: Thu Dec 19, 2013 5:34 pm
by outune
As mentioned-- This will fit Columbia front-mount disc machines ie the AJ, AK-- Also on some Columbia client machines. There would be a brass elbow that slips on the end
Brad