Page 1 of 1
Brunswick Model YO spring repair
Posted: Tue Jan 14, 2014 9:15 am
by Hearsug
I am rebuilding the spring motor on my recently acquired Brunswick Model YO phonoghaph. It appears to be in very good condition, all of the gears, etc. operate freely. Could someone please explain how to disassemble the 2 piece spring housing?
Re: Brunswick Model YO spring repair
Posted: Tue Jan 14, 2014 9:32 am
by alang
Pictures will always help others to better understand the problem and give advice.
Good luck
Andreas
Re: Brunswick Model YO spring repair
Posted: Tue Jan 14, 2014 10:34 am
by Hearsug
Good idea. The attached photo is of the spring housing assembly.
Re: Brunswick Model YO spring repair
Posted: Tue Jan 14, 2014 10:40 am
by Hearsug
attached photo in .jpg
Re: Brunswick Model YO spring repair
Posted: Tue Jan 14, 2014 1:05 pm
by Hearsug
Maybe it is properly called a spring barrel?
Re: Brunswick Model YO spring repair
Posted: Tue Jan 14, 2014 1:20 pm
by Bob
I would put the the side with the smaller gear into a vise. Take a piece of wood and a hammer. Tap around the part that overlaps the other to separate the two halves.
Re: Brunswick Model YO spring repair
Posted: Tue Jan 14, 2014 1:43 pm
by Henry
I'd put it in a vise. A vice might be illegal!