Page 1 of 1
WANTED: back bracket, tone arm, etc for a Victor III
Posted: Wed Nov 19, 2014 9:31 pm
by miker2001
Looking for a back bracket with tone arm for a Victor III? I am also missing the plate and screws to secure it to the case and the parts to hold down the horn elbow. I have the elbow for the horn and horn. This case has the three part corner columns.
Thanks.
Mike Rosen
[email protected]
Re: Wanted: back bracket, tone arm, etc for a Victor III
Posted: Wed Nov 19, 2014 9:33 pm
by Jerry B.
If you can't find a nickel tone arm, I have one in gold that could be re-plated. The clip and screw are available from Sitko. Jerry
Re: WANTED: back bracket, tone arm, etc for a Victor III
Posted: Mon Nov 24, 2014 10:02 am
by cpistocco
I, too, am looking for a back bracket for a vic III (which apparently is the same for a Vic IV M or MS). If you should come across more than one, please let me know. I will do the same for you.
Thanks
Charlie
[email protected]
ps
The tone arm should be easy for you to find because it spans across MANY models.
Re: WANTED: back bracket, tone arm, etc for a Victor III
Posted: Mon Nov 24, 2014 10:17 am
by miker2001
Actually, I found another parts machine locally since I posted this. Between the two machines, I can assemble one complete machine.
Re: WANTED: back bracket, tone arm, etc for a Victor III
Posted: Mon Nov 24, 2014 10:57 am
by cpistocco
any leftovers??
Re: WANTED: back bracket, tone arm, etc for a Victor III
Posted: Sat Nov 29, 2014 1:40 am
by pmonteith
I too am on the hunt for a Vic III back bracket and tone arm in decent shape.
I have a near perfect bracket/arm for a Vic II that I'd consider trading if there's interest.
Re: WANTED: back bracket, tone arm, etc for a Victor III
Posted: Sun Nov 30, 2014 10:27 pm
by cpistocco
I am unsure what a vic III bracket should look like.... Do you know what the dimensions should be? I believe that I have a vic v or VI bracket on My Vic III.....BUT they all look the same!!