The Talking Machine Forum — For All Antique Phonographs & Recordings

I know this is a long shot, but hoping someone here has the tone arm and reproducer for this phonograph. I recently purchased a Stewart Phonograph as a spur of the moment purchase from a seller on eBay. The Stewart Phono is missing the tone arm and reproducer, but otherwise is complete and working. If anyone has the part(s) I need, I would appreciate it, but again, I know it is a long shot, but I though I would try.
Matt

I got a part for my Stewart from George Vollema last year, so you might try him...

FYI... The Stewart has two sizes of tone arms (one big, one small). The small size is 1 inch diameter at the mounting bracket. It's a little hard to tell from the photo, but the stock picture is the smaller of the two. The big one is the most common.

Yours is missing the bottom board.

Thanks for the advice and information. I'll contact George. The opening for the tone arm on this machine is about 1.25 inches. Hopefully I will eventually find one.
Thanks guys.