Page 1 of 1
Repairing Diaphragms-Gasket on both sides?
Posted: Mon Dec 15, 2014 6:04 pm
by Hcompton79
When putting a new diaphragm into a reproducer do gaskets go on both sides or only facing out?
Sorry I'm new to this.
Re: Repairing Diaphragms-Gasket on both sides?
Posted: Mon Dec 15, 2014 6:30 pm
by Phono48
No apologies needed!
Both sides.
Barry
Re: Repairing Diaphragms-Gasket on both sides?
Posted: Mon Dec 15, 2014 7:59 pm
by Jerry B.
Both sides if at all possible. Some reproducers are made of pot metal and you run the risk of breakage from disassembly. Beware if you see lots of little cracks which an indication of something made out of pot metal. Jerry
Re: Repairing Diaphragms-Gasket on both sides?
Posted: Mon Dec 15, 2014 8:06 pm
by Hcompton79
I do believe it is made of pot metal but I see no cracks in it.
Re: Repairing Diaphragms-Gasket on both sides?
Posted: Tue Dec 16, 2014 6:37 am
by Phono48
Which soundbox is it?
Barry
Re: Repairing Diaphragms-Gasket on both sides?
Posted: Tue Dec 16, 2014 7:31 am
by Hcompton79
To be honest I still don't know what machine it is. all I could find was "E General Industries Co Ohio Junior" printed on the motor.