Page 1 of 1
Identify a machine vv ?
Posted: Wed Dec 24, 2014 3:36 am
by designerweddingdj
Can any of you knowledgeable guys id this machine for me
http://www.auctiva.com/hostedimages/sho ... 0&format=0
i thought it was a vv 2-60 but not too sure.
Re: Identify a machine vv ?
Posted: Wed Dec 24, 2014 3:54 am
by Edisone
VV 2-55 ... brutal on records
Re: Identify a machine vv ?
Posted: Wed Dec 24, 2014 9:13 am
by EdiBrunsVic
Yes, it is a VV-2-55. Perhaps using soft tone needles is a good idea.
Re: Identify a machine vv ?
Posted: Fri Dec 26, 2014 5:11 pm
by Torjazzer
I'm pretty sure, from previous posts, that the reproducer is sealed and cannot be opened safely for repair. Anyone?
Re: Identify a machine vv ?
Posted: Fri Dec 26, 2014 7:20 pm
by Uncle Vanya
Torjazzer wrote:I'm pretty sure, from previous posts, that the reproducer is sealed and cannot be opened safely for repair. Anyone?
No that is the VV 2-35, a machine with a simple tone arm without a crook. The 2-55 uses an ordinary Orthophonic sound box with a " scratch muffler" . I've never known these machines to be all that hard n records if the reproducer is I'm good co diction and if the rubber isolator is appropriately soft.
Re: Identify a machine vv ?
Posted: Fri Dec 26, 2014 10:37 pm
by Torjazzer
Uncle Vanya wrote:Torjazzer wrote:I'm pretty sure, from previous posts, that the reproducer is sealed and cannot be opened safely for repair. Anyone?
No that is the VV 2-35, a machine with a simple tone arm without a crook. The 2-55 uses an ordinary Orthophonic sound box with a " scratch muffler" . I've never known these machines to be all that hard n records if the reproducer is I'm good co diction and if the rubber isolator is appropriately soft.
Thanks for clearing that up. However, I have to side with Edisone on the possible damage to records. Looking at the position of the needle chuck in relation to the spindle, I don't know how this machine could track properly. With these two points so out of alignment, I would expect record damage.
Re: Identify a machine vv ?
Posted: Sat Dec 27, 2014 12:19 am
by Uncle Vanya
Well, when the reproducer is properly set on the tone arm the tracking is pretty good, just about as good as that of the 102. I think that the auction pictures are taken at odd angles. Now, the 2-35 is another story. Reproducer rigidly attached to a straight tone arm which is hinged at the back like a Victrolita or a 1908 vintage Columbia. Now THATS brutal!