Are all Columbia type D floating reproducers like this?
Posted: Mon Apr 13, 2015 10:32 pm
Delete this thread please.
The Talking Machine Forum — For All Antique Phonographs & Recordings
https://forum.talkingmachine.info/
Are all Columbia type D floating reproducers like this?
Page 1 of 2
Re: Are all Columbia type D floating reproducers like this?
Posted: Tue Apr 14, 2015 1:15 pm
Can't you put the gasket on top of the raised edge instead of on the bottom surface?
Re: Are all Columbia type D floating reproducers like this?
Posted: Tue Apr 14, 2015 2:21 pm
.
Re: Are all Columbia type D floating reproducers like this?
Posted: Tue Apr 14, 2015 6:35 pm
.
Re: Are all Columbia type D floating reproducers like this?
Posted: Tue Apr 14, 2015 11:10 pm
I'm not familiar with the D reproducer; but it appears to be the D-2B, as pictured in Hazelcorn's book.
Now, is the problem that the inner gasket does not sit properly on the ledge? Or does the outer gasket stand proud of the body of the reproducer after you put the diaphragm in?
Bill
Now, is the problem that the inner gasket does not sit properly on the ledge? Or does the outer gasket stand proud of the body of the reproducer after you put the diaphragm in?
Bill
Re: Are all Columbia type D floating reproducers like this?
Posted: Tue Apr 14, 2015 11:24 pm
.
Re: Are all Columbia type D floating reproducers like this?
Posted: Thu Apr 16, 2015 12:30 am
Instead of deleting posts, it would be more informative to post a response.
I hope you have found the solution to your problem.
Bill
I hope you have found the solution to your problem.
Bill
Re: Are all Columbia type D floating reproducers like this?
Posted: Thu Apr 16, 2015 7:12 am
Seriously. This could have been helpful for somebody looking for an answer to this in the future.
Sean
Sean
Re: Are all Columbia type D floating reproducers like this?
Posted: Thu Apr 16, 2015 1:26 pm
Thanks, I'll try to help you again some time.... 
Re: Are all Columbia type D floating reproducers like this?
Posted: Thu Apr 16, 2015 5:55 pm
The reason I deleted all of my posts is because I was embarrassed and felt ridiculous for asking because I realized that it was as simple as making a thinner gasket. I guess I was just being hard on myself. I certainly wasn't angry at anyone on this forum and thank you for your answers. Jerry, you were right. I can put a gasket on the raised ledge. Bill, yes my problem was that after I installed the bottom gasket and diaphragm it would not leave enough room for the bezel. Sean, you're right I shouldn't have deleted all my posts.
Again I'm very sorry to everyone. Will you accept my apology?
Again I'm very sorry to everyone. Will you accept my apology?