Page 1 of 1
Attaching Victrola Data Plate
Posted: Sun Jun 21, 2015 7:44 pm
by Victrolacollector
I need to attach a Victrola data plate to my machine.
What was used to do this? Were these nails or brads? What length or size?
Re: Attaching Victrola Data Plate
Posted: Sun Jun 21, 2015 7:58 pm
by De Soto Frank
Looks like steel escutcheon-pins on my 1909 L-Door and 1927 Orthophonic.
Brass (?) escutcheon pins on my 1918 XI.
Re: Attaching Victrola Data Plate
Posted: Mon Jun 22, 2015 11:36 am
by Jerry B.
You can purchase small brass pins. If they are a bit long, just snip them at an angle. Jerry