The Talking Machine Forum — For All Antique Phonographs & Recordings

Almost done with the little Lakeside backmount cylinder machine (it's been on the shelf for over 20 years while locating missing parts). Last item is the halfnut and spring bracket that it mounts to and that in turn mounts to the reproducer carriage (about two inches long). Assume this would be the same as the inside horn Lakeside. Could also use a mint gear cover that says "IN OUT and 2 - 4, although I can paint mine and hope that Gregg Cline can make me a decal. Any help greatly appreciated.

Kent 913-888-0751 or email.

Any help appreciated - maybe someone can reproduce the bracket/halfnut or supply dimensions to help me out? Would consider a basket-case Lakeside inside horn.