The Talking Machine Forum — For All Antique Phonographs & Recordings

I have adjusted the governor on this early motor (VV-XI), it sounds a little noisy. I also rubbed my hand across the bull gear, it feels sharp, so I suspect the bull gear needs replaced.

I then looked at the governor brass drive gear, and there ware some dings (burrs) in that gear.
Are these quad-cut gears (bull gears and governor drive gears the same on all the later Victrola's)

I just need to know so that I can get replacements, or should I just not be concerned with replacement?

Send George an email (or call). I'm sure he can help you with all your motor questions and replacements.. .
www.victroladoctor.com