The Talking Machine Forum — For All Antique Phonographs & Recordings

Has anyone had cabinet pieces reproduced, if so where?

What parts and for what cabinets?

I've had pieces made by Jerry Rutkowski at grampstreasures.com, and he does a wonderful job.

Bill

Curt A wrote:What parts and for what cabinets?

I have a VV-107 that the lid is in pieces, i have one good side for a pattern

oltractor wrote:

Curt A wrote:What parts and for what cabinets?

I have a VV-107 that the lid is in pieces, i have one good side for a pattern

You might also want to consider checking with George Vollema to see if he has an original available.

Clay

FloridaClay wrote:

oltractor wrote:

Curt A wrote:What parts and for what cabinets?

I have a VV-107 that the lid is in pieces, i have one good side for a pattern

You might also want to consider checking with George Vollema to see if he has an original available.

Clay[/q

I have, and every other place I could find, no parts anywhere

Sorry to hear that. George has worked parts miracles for me so often I get to thinking he always can. 107s were low production and survivors, I would think, must be fairly uncommon.

Clay

Finding an original lid to a 107 is going to be tough. Only about 1000 were produced. If you have one side, a good woodworker should be able to reproduce the profile for you. You might even check with places that make millwork and cabinets. I had some missing moldings in my house reproduced at a local millwork shop.