Page 1 of 1
WANTED: Parts for Victor VV-IV
Posted: Fri Aug 28, 2015 11:06 pm
by 52089
I picked up a nice VV-IV project (type D) today but it's not complete. I need the following:
Tonearm and reproducer U-tube, with or without support bracket
Turntable
Crank
Please PM if you can help.
Thanks,
Kevin
Re: WANTED: Parts for Victor VV-IV
Posted: Sat Aug 29, 2015 1:26 am
by Jerry B.
Kevin, The VV-IV was made for quite a few years and went through numerous changes including every part you need. I'd suggest you post a photo of your machine including the ID tag. It will give Forum members a starting point. Jerry Blais
Re: WANTED: Parts for Victor VV-IV
Posted: Sat Aug 29, 2015 12:23 pm
by Phonofreak
Kevin, I checked my Victor Data book. I think I can help you. PM sent.
Harvey Kravitz
Re: WANTED: Parts for Victor VV-IV
Posted: Sat Aug 29, 2015 10:01 pm
by 52089
Pictures as requested.
Re: WANTED: Parts for Victor VV-IV
Posted: Sun Sep 13, 2015 9:02 pm
by 52089
Turntable and crank located. Still looking for tonearm assembly. I am told it is the same arm as the Victor I, II, and O.
Re: WANTED: Parts for Victor VV-IV
Posted: Tue Sep 15, 2015 7:50 am
by edisonrestorer64
Really Nice Kevin I have a victor Victrola 6 I've restored some what there great machines
Re: WANTED: Parts for Victor VV-IV
Posted: Fri Sep 25, 2015 11:43 pm
by 52089
Tonearm located, so once I clean up the motor and cabinet, it should be ready for its "debut".
I could still use the little screws that hold the tonearm bracket onto the horn, and a couple of the screws that hold the motor board onto the rest of the cabinet. Please PM if you can help.