Page 1 of 1
WANTED: Cylinder Cabinet Drawer Pulls
Posted: Mon Sep 21, 2015 9:22 am
by ChuckA
I'm looking for a set of 5 drawer pulls for a cabinet I recently bought. Someone replaced the original brass with cheap wood knobs.
What the originals look like:
They are single hole mount.
Chuck
Re: WTB: Cylinder Cabinet Drawer Pulls
Posted: Mon Sep 21, 2015 10:00 am
by rgordon939
They look like H&S drawer pulls, very hard to find.
Rich Gordon
Re: WTB: Cylinder Cabinet Drawer Pulls
Posted: Mon Sep 21, 2015 5:11 pm
by ChuckA
rgordon939 wrote:They look like H&S drawer pulls, very hard to find.
Rich Gordon
Rich,
Of course they have to be hard to find, everything I go after at an auction or look for is either almost impossible to find or one of the most expensive pieces in the auction.
Chuck
Re: WTB: Cylinder Cabinet Drawer Pulls
Posted: Wed Sep 23, 2015 1:33 pm
by edisonrestorer64
this is so true I need Three side that are mounted for the drawer sliders and the draws also
really tough to locate.
Re: WTB: Cylinder Cabinet Drawer Pulls
Posted: Wed Sep 23, 2015 1:52 pm
by emerson
Chuck, Do you have any to make a copy from? Always good seeing you at the show--where was the big guy, didn't see him?
Re: WTB: Cylinder Cabinet Drawer Pulls
Posted: Wed Sep 23, 2015 4:22 pm
by ChuckA
emerson wrote:Chuck, Do you have any to make a copy from? Always good seeing you at the show--where was the big guy, didn't see him?
Yes I have some originals, but usually the cost to have new castings made is way above what I could buy another cabinet for. If I can't find them, I'll use some new ones that look better than the doorknobs that are on it now.
Good seeing you also, Les is slowing down a little and decided not to make the trip this time maybe the spring show.
Chuck