Page 1 of 1
Question on Edison model N Reproducer
Posted: Thu Dec 17, 2015 7:42 pm
by flashpanblue
Hello,
Does anyone know if they make a new reproduction top half for the Edison model N reproducer?
Thanks
Re: Question on Edison model N Reproducer
Posted: Fri Dec 18, 2015 7:51 am
by FloridaClay
flashpanblue wrote:Hello,
Does anyone know if they make a new reproduction top half for the Edison model N reproducer?
Thanks
You might try Steve Medved.
Clay
Re: Question on Edison model N Reproducer
Posted: Fri Dec 18, 2015 11:55 am
by rgordon939
Hi Pete. The N reproducer came out in 1911 and was followed shortly after by the model O. They shared serial numbers. The first O reproducers had a flat top pot metal top and a round weight in the 25000 s/n range. Around 45000 the dome top N appeared. The difference between the N and the O was weights they used . You could use one of large reproduction tops you see on ebay sold by landajus. If the problem is that your N body is chipped Steve Medved can repair it. He did one for me and it looks pretty good.
Rich Gordon