Page 1 of 1
WANTED: Holder for Edison Disc Reproducer
Posted: Wed Mar 02, 2016 9:48 am
by phonogfp
I've been hoping to find one of the clamp-on holders for an Edison Disc Reproducer like the one shown here:
- holder.JPG (64.49 KiB) Viewed 605 times
If anyone has one of these holders for sale, I'd love to hear from you!
George Paul
Re: WANTED: Holder for Edison Disc Reproducer
Posted: Wed Mar 02, 2016 11:47 pm
by gsphonos
Wow--is that a nickel plated long play? I have the uncommon gold LP and a couple of the bronze (the most common finish--can't remember if it is called bronze) LP's, but I have never seen a nickel plated one. That must be rarer than an LP with gold finish.
I have the 2 clip and the 1 clip diamond disc reproducer holders--but they need a screw(s), so I much prefer one like you have pictured, because you don't have to use the screw!! Good luck finding one. I think someone was making a reproduction of this one??
Mike Sorter
Re: WANTED: Holder for Edison Disc Reproducer
Posted: Thu Mar 03, 2016 9:38 am
by phonogfp
gsphonos wrote: I think someone was making a reproduction of this one??
Mike Sorter
Gee, I wish someone would!
I'd be obliged to learn about it.
George P.
Re: WANTED: Holder for Edison Disc Reproducer
Posted: Thu Mar 03, 2016 11:45 am
by fran604g
phonogfp wrote:gsphonos wrote: I think someone was making a reproduction of this one??
Mike Sorter
Gee, I wish someone would!
I'd be obliged to learn about it.
George P.
Same here!
Re: WANTED: Holder for Edison Disc Reproducer
Posted: Thu Mar 03, 2016 4:25 pm
by A Ford 1
I would buy two at least.
Allen