Page 1 of 1
WANTED: Standard Talking Machine Part
Posted: Sat May 28, 2016 12:52 pm
by downsouth
Hey guys, I am in need of the on/off plunger, speed control rod and spring for a Standard Talking Machine Model A. Any help
in finding this part would be greatly appreciated!
Regards, Wes
Re: WANTED: Standard Talking Machine Part
Posted: Mon May 30, 2016 9:55 am
by downsouth
If anyone has the small brass knob that goes on the push- pull rod, I could use of those as well.
Regards, Wes
Re: WANTED: Standard Talking Machine Part
Posted: Tue May 31, 2016 7:31 am
by fmblizz
what length are you looking for?? I have both items but not sure it will fit your machine.
blizz
Re: WANTED: Standard Talking Machine Part
Posted: Tue May 31, 2016 8:04 am
by downsouth
It appears that the one I need measures around 4 ¾-5" in length. Now this is measuring the on/off rod length and not the barrel. If it measures close to this or a little longer it should be fine. I thought I had found what I was looking for a while back but when I received the part, it was too short. Apparently it was for a BH or the like. Just let me know.
Regards, Wes
Re: WANTED: Standard Talking Machine Part
Posted: Tue May 31, 2016 11:44 am
by downsouth
PM sent Blizz
Wes