The Talking Machine Forum — For All Antique Phonographs & Recordings

Hi,
I know it's a long shot, but I'm looking for the small bottom trim block in the picture below. It's actually for a Vic C, but I think a E will work too. I know I can get one from Sitko, but I thought I might take a chance here first to see if anyone had a junker cabinet.
Thanks,
Bob

What is the exact size? Jerry

Hi Bob- As Jerry said, post the size you need. I have a bottom block piece that is 13/16" square-- if it works, it's yours-- I hope to be down your way later in September, so will bring it when I come.

Brad

Thanks Jerry and Brad...I should have posted measurements.

The block is 1" wide, ½" tall, and ¼" thick. I guess anything bigger would work too.

thanks,
bob

I have bought replacement wooden blocks and corner columns for a Victor E and Humpback II from Tim Fizer In Indiana. He does great work and is very helpful.

I have a victor e junker cabinet. I could pull off a corner block if you still need one.

That's for the help. I found one that matches. Bob

Sorry...meant to say THANKS for the help !!