Page 1 of 1
Wanted tone arm and bracket for Victor ms
Posted: Wed Oct 12, 2016 9:23 am
by Lynn
i tried a bracket and tone arm from a Victor lll but it didn't seem to be the proper height
Re: Wanted tone arm and bracket for Victor ms
Posted: Wed Oct 12, 2016 10:41 am
by Jerry B.
I've always believed the back bracket needed for a MS is the same as a M, III, or IV. Does your cabinet have two sets of mounting holes for the back bracket. I think one set of holes were used when a Concert sound box was used and the other for an Exhibition. That would chance the height of the tone arm and reproducer in relation to the turntable. I am not familiar with Rigid arm Victors and I'm assuming yours is not a Rigid arm machine.
Jerry Blais
Re: Wanted tone arm and bracket for Victor ms
Posted: Wed Oct 12, 2016 7:19 pm
by Lynn
Your right, there are two sets of holes. I thought someone may have tried to use a different bracket. Thats good to know. I will take a bracket off a lll and try it again. Thanks so much Jerry I appreciate you sharing your knowledge .
Re: Wanted tone arm and bracket for Victor ms
Posted: Thu Oct 13, 2016 8:26 am
by Jerry B.
If you can't find an original, Ron Sitko sells a good reproduction. Jerry
Re:FOUND: tone arm and bracket for Victor ms
Posted: Thu Feb 16, 2017 9:38 am
by Lynn
Thanks Jerry!!!