Page 1 of 1
remove\replace Victrola XI sheared of pin in main worm gear
Posted: Wed Oct 26, 2016 1:37 pm
by wheatgrinder
Hi all,
the "platter" pin that goes through the top of the main worm drive gear in my victor VV-XI is sheared off. Should I try and get it out or just find a new main worm drive gear?
Tips?
(sorry, I think this was posted in the wrong area.. Admin, please move appropriately)
Re: remove\replace Victrola XI sheared of pin in main worm g
Posted: Wed Oct 26, 2016 9:02 pm
by Phonofreak
I'm trying to visualize this. You might have to have a machinist or a clock repairman drill out and replace the pin. When you say platter pin, is that the pin that goes through the spindle shaft that locks the turn table in place? If so,then that is an easy fix. You will need a 1/32" punch to remove the pin. Then I would use a small nail and trim the length with a dremel tool. Then I would use ACC glue to hold in in place. If that is not the pin we are talking about, then my first suggestion will be the logical choice.
Harvey Kravitz
Re: remove\replace Victrola XI sheared of pin in main worm g
Posted: Wed Oct 26, 2016 9:10 pm
by wheatgrinder
Yes, thats it exactly! The pin that passes through the worm gear shaft and locks the turntable in place.
ill fix it when i do the breakdown \ deep clean over my next holiday break. rust and tight fit are keeping it in place now
Thanks again!
Re: remove\replace Victrola XI sheared of pin in main worm g
Posted: Wed Oct 26, 2016 10:55 pm
by Phonofreak
Great, we're on the same page. That's a very common problem and an easy fix. Good luck with the repair. I have done this many times.
Harvey Kravitz
Re: remove\replace Victrola XI sheared of pin in main worm g
Posted: Mon Oct 31, 2016 3:04 pm
by startgroove
That pin is hard, it would be difficult to drill out, and hard to keep the hole straight (if the drill is not perfectly aligned, you could drill the hole off kilter, or a larger diameter). They usually are not too difficult to punch out, even if it appears rusty. I would reserve the drill as a last resort.
Re: remove\replace Victrola XI sheared of pin in main worm g
Posted: Mon Oct 31, 2016 9:19 pm
by Phonofreak
I have done that many times when the pin was stuck, and it works great. I never had a problem with it being off kilter or center. The secret is proper alignment.
Harvey Kravitz
startgroove wrote:That pin is hard, it would be difficult to drill out, and hard to keep the hole straight (if the drill is not perfectly aligned, you could drill the hole off kilter, or a larger diameter). They usually are not too difficult to punch out, even if it appears rusty. I would reserve the drill as a last resort.