Page 1 of 1
Wanted - Brunswick Reproducer Screw
Posted: Mon Jan 23, 2017 4:30 pm
by donniej
I was rebuilding an Ultona reproducer and lost one of the screws that holds the diaphragm's flange on. A close-up of one is attached. Please reply or message me if you know where I can find one. Thank you.
Re: Wanted - Brunswick Reproducer Screw
Posted: Wed Jan 25, 2017 4:38 pm
by Kevan
Is that 1 of 4 screws that holds the flange again'st the white tube gasket? They are very small and hard to find when you drop them. I once dropped a blue sapphire for a puck reproducer on the kitchen floor and I looked for hours for it but never found it. I have just rebuilt a brunswick ultona myself and it sounds great. I had to use two reproducers to get one good one
isn't that always the way. I can send you some if you want.
Kevan
Re: Wanted - Brunswick Reproducer Screw
Posted: Wed Jan 25, 2017 8:42 pm
by donniej
Thank you!
Please check your messages.