SOLD!!: BERLINER FIBER GEAR FOR MONTROSS BERLINER
Posted: Fri Feb 10, 2017 6:03 pm
Looking through my stash of shits and bits this week, I stumbled across a very special replica "Montross" Berliner fiber gear.
NOTE: THIS IS NOT THE SAME GEAR AS A "TRADEMARK" BERLINER! IT'S NOT EVEN CLOSE!
However, it DOES have the same dimensions and is correct for some early Victor motors that have a VERTICAL governor orientation, driven by this fiber gear. I cannot remember which ones though. Made out of the exact same material as used more than a century ago.
It also does NOT fit any of the "ratchet wind variety" of Berliners either.
Gear diameter is exactly 2.580" just shy of 2 ⅝". This gear has a much finer pitch of teeth than the "trademark" gear.
If someone is interested, the first $100.00US takes it + shipping to your address.
This is the LAST gear from a run of various Berliner fiber gears I did years ago. Made with the attention to detail that you all know and love
Thanks for lookin' and PayPal only please.
Cheers,
Darren
NOTE: THIS IS NOT THE SAME GEAR AS A "TRADEMARK" BERLINER! IT'S NOT EVEN CLOSE!
However, it DOES have the same dimensions and is correct for some early Victor motors that have a VERTICAL governor orientation, driven by this fiber gear. I cannot remember which ones though. Made out of the exact same material as used more than a century ago.
It also does NOT fit any of the "ratchet wind variety" of Berliners either.
Gear diameter is exactly 2.580" just shy of 2 ⅝". This gear has a much finer pitch of teeth than the "trademark" gear.
If someone is interested, the first $100.00US takes it + shipping to your address.
This is the LAST gear from a run of various Berliner fiber gears I did years ago. Made with the attention to detail that you all know and love
Thanks for lookin' and PayPal only please.
Cheers,
Darren