Page 1 of 1
FOUND: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 8:32 am
by hearsedriver
I am in need of the flat bar that holds the half nut/feed nut to the carriage on a Edison Standard B phonograph. If anyone has a B they are parting out, please give me a shout. Thanks!
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 9:18 am
by Dave D
Did it break while you were attempting to adjust it? It has happened to others, too!
Dave D
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 9:19 am
by hearsedriver
Dave D wrote:Did it break while you were attempting to adjust it? It has happened to others, too!
Dave D
Yes it did. Snapped like a piece of glass.
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 10:32 am
by Jerry B.
Doesn't Ron Sitko sell those parts? Jerry Blais
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 12:17 pm
by Phono-Phan
This is the reason why I don't bend this bar to make the adjustments. It is best to shim under the bar with thin pieces of paper.
Ken
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 2:37 pm
by hearsedriver
Ken, I have to learn everything the hard way
Hopefully, someone here will have one for me. I'm dead in the water without it.
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 2:56 pm
by gramophone-georg
hearsedriver wrote:Ken, I have to learn everything the hard way
Hopefully, someone here will have one for me. I'm dead in the water without it.
Stupid question. Is it just a flat piece of metal?
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 5:53 pm
by hearsedriver
gramophone-georg wrote:hearsedriver wrote:Ken, I have to learn everything the hard way
Hopefully, someone here will have one for me. I'm dead in the water without it.
Stupid question. Is it just a flat piece of metal?
Basically, yes but, its a hard , spring steel. I may have to make one out of a saw blade or something.
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 6:19 pm
by gramophone-georg
hearsedriver wrote:gramophone-georg wrote:hearsedriver wrote:Ken, I have to learn everything the hard way
Hopefully, someone here will have one for me. I'm dead in the water without it.
Stupid question. Is it just a flat piece of metal?
Basically, yes but, its a hard , spring steel. I may have to make one out of a saw blade or something.
How about a thick automotive feeler gauge?
Re: Wanted: Half Nut Bar for Edison Standard B
Posted: Sat Feb 25, 2017 6:21 pm
by hearsedriver
How about a thick automotive feeler gauge?[/quote]
Too soft.